HOME
Cart(0)
Quotation
About-Us
Tax
PDFs
Standard-List
Powered by Google
www.ChineseStandard.net
Database: 189759 (8 Jun 2025)
PDF GB 1886.318-2021 English
Search result: GB 1886.318-2021
Standard ID
Contents [version]
USD
STEP2
[PDF] delivered in
Name of Chinese Standard
Status
GB 1886.318-2021
English
110
Add to Cart
0-9 seconds. Auto-delivery.
National food safety standard - Food additives - Zeaxanthin
Valid
PDF Preview: GB 1886.318-2021
GB 1886.318-2021: PDF in English
GB 1886.318-2021 GB NATIONAL STANDARD OF THE PEOPLE’S REPUBLIC OF CHINA National Food Safety Standard - Food Additives - Zeaxanthin ISSUED ON: FEBRUARY 22, 2021 IMPLEMENTED ON: AUGUST 22, 2021 Issued by: National Health Commission of the People’s Republic of China; State Administration for Market Regulation. Table of Contents 1 Scope ... 3 2 Chemical Name of Main Components, Molecular Formula, Structural Formula and Relative Molecular Mass ... 3 3 Technical Requirements ... 3 Appendix A Inspection Methods ... 5 Appendix B Liquid Reference Chromatograms of Zeaxanthin, Cryptoxanthin and Lutein Standard Solutions ... 9 National Food Safety Standard - Food Additives - Zeaxanthin 1 Scope This Standard is applicable to corn and/or food additive of zeaxanthin that takes the corn as raw materials, and is prepared through extracting and concentrating the extraction solvents of vegetable oil. 2 Chemical Name of Main Components, Molecular Formula, Structural Formula and Relative Molecular Mass 2.1 Molecular formula Zeaxanthin: C40H56O2 2.2 Structural formula Zeaxanthin: 2.3 Relative molecular mass Zeaxanthin: 568.87 (as per 2016 international relative atomic mass) 3 Technical Requirements 3.1 Sensory requirements The sensory requirements shall comply with the provisions of Table 1. Appendix A Inspection Methods A.1 General provisions If no other requirements are specified, all the reagents and water used in this Standard refer to the analytical reagents and Class-III water specified in GB/T 6682. If no other requirements are specified, all the standard solution used in the test, standard solution for determining the impurity, preparation and product shall be prepared according to the provisions of GB/T 601, GB/T 602, GB/T 603.The solution used in the test refers to the aqueous solution when the solvent is not specified. A.2 Identification test Take an appropriate amount of specimen and dissolve it in chloroform. The specimen solution shall have a maximum absorption peak in the wavelength range of 455nm ± 10nm. A.3 Determination of colour value A.3.1 Reagents and materials Chloroform. A.3.2 Apparatus Ultraviolet-visible spectrophotometer. A.3.3 Analysis procedures Accurately weigh 0.1g of specimen (accurate to 0.0001g), dissolve it by chloroform; transfer to a 100mL volumetric flask; add chloroform to make constant volume to the mark; and shake well. Use this solution as a specimen solution; place it in a 1cm cuvette; use chloroform as a blank control; and use an ultraviolet-visible spectrophotometer to measure the absorbance (the absorbance shall be controlled at 0.3~ 0.7; otherwise, the concentration of the specimen solution shall be adjusted; and then the absorbance shall be re-measured) at the maximum absorption wavelength of 455nm±10nm. A.3.4 Calculation of results The colour value E1% 1cm (455nm±10nm) is calculated according to Formula (A.1).
......
Source: Above contents are excerpted from the PDF -- translated/reviewed by: www.chinesestandard.net / Wayne Zheng et al.