GB/T 29124-2025 (GB/T 29124-2012) PDF EnglishUS$85.00 · In stock · Download in 9 seconds
GB/T 29124-2012: Hydrogen fuel cell vehicles facilities for demonstration specifications Delivery: 9 seconds. True-PDF full-copy in English & invoice will be downloaded + auto-delivered via email. See step-by-step procedure Status: Valid GB/T 29124: Historical versions
Similar standardsGB/T 29124-2012: Hydrogen fuel cell vehicles facilities for demonstration specifications---This is an excerpt. Full copy of true-PDF in English version (including equations, symbols, images, flow-chart, tables, and figures etc.), auto-downloaded/delivered in 9 seconds, can be purchased online: https://www.ChineseStandard.net/PDF.aspx/GBT29124-2012GB NATIONAL STANDARD OF THE PEOPLE’S REPUBLIC OF CHINA ICS 43.020 T 04 Hydrogen Fuel Cell Vehicles Facilities for Demonstration – Specifications Issued on: DECEMBER 31, 2012 Implemented on: JULY 1, 2013 Issued by. General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China; Standardization Administration of the People's Republic of China. Table of ContentsForeword ... 3 1 Scope ... 4 2 Normative References ... 4 3 Terms and Definitions ... 4 4 Basic Conditions for Demonstration ... 5 5 Basic Requirements ... 5 6 Hydrogen Refueling Stations (Vehicles) and Hydrogen Refueling ... 6 7 Parking Lots and Maintenance Shops ... 7ForewordThis Standard was drafted in accordance with the rules given in GB/T 1.1-2009. This Standard was proposed by the Ministry of Industry and Information Technology of the People’s Republic of China. This Standard shall be under the jurisdiction of the National Technical Committee of Auto Standardization (SAC/TC 114). The drafting organizations of this Standard. Tsinghua University and China Automotive Technology & Research Center. The main drafters of this Standard. Chen Quanshi, Zhu Jialian, He Yuntang and Tian Guangyu. Hydrogen Fuel Cell Vehicles Facilities for Demonstration – Specifications1 ScopeThis Standard specifies the terms and definitions of compressed hydrogen fuel cell vehicles facilities for demonstration, basic conditions for demonstration, basic requirements, hydrogen refueling stations (vehicles) and hydrogen refueling, and relevant specifications for parking lots and maintenance shops. This Standard applies to hydrogen refueling stations, parking lots and maintenance shops for hydrogen fuel cell vehicles for demonstration (hereinafter referred to as vehicles) whose compressed hydrogen system’s rated working pressure is not greater than 35 MPa.2 Normative ReferencesThe following documents are essential to the application of this standard. For dated references, only the dated editions apply to this standard. For undated references, the latest edition (including all amendments) applies to this standard. GB/T 24548 Fuel Cell Electric Vehicles – Terminology GB 50177 Design Code for Hydrogen Station QC/T 816-2009 Specification of Mobile Hydrogen Refueling Vehicles3 Terms and DefinitionsThe following terms and definitions and those defined in GB/T 24548 apply to this document. 3.1 Facilities for demonstration Facilities for demonstration refer to hydrogen refueling stations, parking lots and maintenance shops and others required for demonstration. 3.2 Hydrogen vent pipe Hydrogen vent pipe refers to a special hydrogen vent channel which is fixed in a building and used for vehicles to discharge hydrogen indoors. 5.6 Do not discharge hydrogen indoors; if purging, replacement, emptying for depressurization or other operations is carried out indoors for hydrogen systems, hydrogen vent pipes shall be used to discharge hydrogen outdoors safely. 5.7 In case of a leakage or concentration of hydrogen, immediately cut off the gas source; ventilate the room; and do not carry out any operation that may generate sparks. 5.8 If an open flame needs to be used for vehicles or hydrogen systems, it shall be guaranteed that the concentration of hydrogen inside of hydrogen systems within hot work area does not exceed its lower flammability limit. 5.9 When a hydrogen leakage test is carried out for the pipes, valves, joints and others of hydrogen systems, apparatus and method shall be used as specified.6 Hydrogen Refueling Stations (Vehicles) andHydrogen Refueling 6.1 Management of hydrogen refueling stations (areas) 6.1.1 Conspicuous barriers between hydrogen refueling stations (areas) and the outside world as well as clear entrances and exits shall be provided. 6.1.2 Smoking or use of open flame are prohibited; if an open flame must be used because equipment maintenance etc., a hot work can only be done after it is approved, relevant rules shall be followed, reliable safety measures shall be taken. 6.1.3 Spacing between vehicles within hydrogen refueling stations (areas) shall meet the criteria of emergency evacuation. 6.2 Hydrogen refueling operation 6.2.1 Before hydrogen refueling, fuel cell systems and vehicles’ high voltage systems shall be shut down; and vehicles shall be earthed at hydrogen refueling stations (unless that the manufacturer of vehicles declares that earthing is not necessary). 6.2.2 The following rules shall be followed during hydrogen refueling operation. 6.2.2.1 In case of adverse weather such as strong lightning or an emergency adverse to hydrogen refueling safety that occurs inside or outside of hydrogen refueling stations, follow the rules of the Safety Accidents Emergency Response Plan for Demonstration, stop hydrogen refueling operation and shut down power sources and gas sources. 6.2.2.2 When vehicles get in a station for hydrogen refueling, drivers shall follow relevant rules for hydrogen refueling stations. ......Source: Above contents are excerpted from the full-copy PDF -- translated/reviewed by: www.ChineseStandard.net / Wayne Zheng et al. |
