GB/T 22366-2022 English PDFUS$564.00 · In stock
Delivery: <= 5 days. True-PDF full-copy in English will be manually translated and delivered via email. GB/T 22366-2022: Sensory analysis - Methodology - General guidance for measuring odour, flavour and taste detection thresholds by a three-alternative forced-choice(3-AFC)procedure Status: Valid GB/T 22366: Historical versions
Basic dataStandard ID: GB/T 22366-2022 (GB/T22366-2022)Description (Translated English): Sensory analysis - Methodology - General guidance for measuring odour, flavour and taste detection thresholds by a three-alternative forced-choice(3-AFC)procedure Sector / Industry: National Standard (Recommended) Classification of Chinese Standard: X04 Classification of International Standard: 67.240 Word Count Estimation: 31,35 Date of Issue: 2022-10-12 Date of Implementation: 2023-05-01 Older Standard (superseded by this standard): GB/T 22366-2008 Issuing agency(ies): State Administration for Market Regulation, China National Standardization Administration GB/T 22366-2022: Sensory analysis - Methodology - General guidance for measuring odour, flavour and taste detection thresholds by a three-alternative forced-choice(3-AFC)procedure---This is a DRAFT version for illustration, not a final translation. Full copy of true-PDF in English version (including equations, symbols, images, flow-chart, tables, and figures etc.) will be manually/carefully translated upon your order. Sensory analysis - Methodology - General guidance for measuring odor, flavor and taste detection thresholds by a three-alternative forced-choice(3-AFC)procedure ICS 67.240 CCSX04 National Standards of People's Republic of China Replacing GB/T 22366-2008 Sensory Analysis Methodology Three-point forced choice (3-AFC) General Guidelines for Smell, Taste, and Flavor Perception Thresholds (ISO 13301.2018, IDT) Released on 2022-10-12 2023-05-01 implementation State Administration for Market Regulation Released by the National Standardization Management Committee table of contentsPreface I Introduction II 1 Scope 1 2 Normative references 1 3 Terms and Definitions 1 4 Basic principles 3 4.1 Inspection step 3 4.2 Data processing 3 5 Inspection procedure 3 5.1 Sample preparation 3 5.2 Stimulus concentration selection 4 5.3 Sample provision 4 5.4 Evaluator Training 5 5.5 Evaluator Selection 5 5.6 Experimental Design 6 6 Data processing 8 6.1 Mathematical and statistical models 8 6.2 Data Pre-inspection 8 6.3 Maximum likelihood method and error limit estimation of logistic model data fitting 9 6.4 Interpretation of results 9 6.5 Situations when the probability of detection (pd) is not equal to 0.510 6.6 Best Estimation Threshold (BET) Estimation 10 6.7 Presentation of results 11 Appendix A (informative) Estimation of the number of assessors required for a given precision12 Appendix B (informative) Example 13 Reference 25forewordThis document is in accordance with the provisions of GB/T 1.1-2020 "Guidelines for Standardization Work Part 1.Structure and Drafting Rules for Standardization Documents" drafting. This document replaces GB/T 22366-2008 "Methodology of sensory analysis using three-point matching method (3-AFC) for the determination of smell, taste and General guidelines for flavor perception thresholds, compared with GB/T 22366-2008, except for structural adjustments and editorial changes, the main technical changes as follows. a) Change the note in "Scope" to the content of the text, and change "Chemical Irritant" to "Stimulus" (see Chapter 1,.2008 edition Chapter 1); b) change the terms "stimulus", "test sample" and "three-point matching test" to "stimulus", "test sample" and "three-point forced choice test", and Modified the definition of "three-point forced choice test" (see 3.1, 3.4 and 3.5, 3.1, 3.4 and 3.5 of the.2008 edition); c) Changed the content in "Inspection Steps" (see 4.1, 4.1 of the.2008 edition); d) Deleted the requirement for reviewers to submit results in "Data Processing" (see 4.2 of the.2008 edition); e) Deleted the item "if the evaluator is familiar with the sample, this deviation can be reduced through intensive training" in "evaluator's training". Content (see 5.4 of the.2008 edition); f) Changed the requirements to be observed in the "General Provisions" (see 5.5.1, 5.5.1 of the.2008 edition); g) Figure 2 "Distribution of population smell thresholds" was changed (see Figure 2, Figure 2 of the.2008 edition); h) Changed "pd" to "pc" in "Mathematical and statistical models" (see 6.1, 6.1 of the.2008 edition); i) The content of positive and negative conditions of parameter b has been added (see 6.3.2); j) Changed the content of "Result Interpretation" (see 6.4, 6.4 of the.2008 edition); k) Changed the content in "Results and calculations based on maximum likelihood method", (see B.2.3, B.2.3 of the.2008 edition); l) Changed the content in the table "Initial estimation of step size error limit in threshold estimation" (see Table B.4, Table B.4 of the.2008 edition); m) Added relevant content on the use of regression models in "Calculation by Linear Regression Method", and changed "log" to "ln" (see B.2.4, B.2.4 of the.2008 edition); n) Added the description of B.2 in "Results and calculations" (see B.3.3); o) Change the comparison of model 3 from "1 and 3" to "2 and 3" (see Table B.6, Table B.6 of the.2008 edition); p) Change "terpinene" to "pinene" (see B.4, B.4 of the.2008 edition); q) Change the ln(C) of "α-pinene" and "β-pinene" when C is 1.000mL/m3 from "-2.30" to "0.00" (see Table B.7, Table B.7 of the.2008 edition). This document is equivalent to ISO 13301.2018 "Sensory Analysis Methodology using three-point forced choice method (3-AFC) to measure the sense of smell, General Guidelines for Taste and Flavor Perception Thresholds. Please note that some contents of this document may refer to patents. The issuing agency of this document assumes no responsibility for identifying patents. This document is proposed and managed by the National Standardization Technical Committee on Sensory Analysis (SAC/TC566). This document is drafted by. China National Institute of Standardization, Jiangsu University, Heilongjiang Feihe Dairy Co., Ltd., Liheweiwei (Qingdao) Food Co., Ltd. Industry Co., Ltd., Academy of Mathematics and Systems Science, Chinese Academy of Sciences, Yuanqi Forest (Beijing) Food Technology Group Co., Ltd., China Green Color Food Co., Ltd., Zhejiang Technology and Business University, Beijing Technology and Business University, Beijing Forestry University, Aipu Spice Group Co., Ltd. The main drafters of this document. Zhong Kui, Zhang Di, Zhao Lei, Liu Wen, Wang Houyin, Feng Shiyong, Song Huanlu, Shi Bolin, Yao Min, Li Yilin, Zhang Yongchang, Li Lin, Cao Kelu, Tang Fei, Liu Ye, Tian Shiyi, Zhu Baoqing, Zou Xiaobo, Chen Bo, Wang Heyan, Zhang Lulu, Wang Sisi. The release status of previous versions of this document and the documents it replaces are as follows. ---It was first published as GB/T 22366-2008 in.2008; --- This is the first revision.Introduction"Threshold" is an important term in sensory analysis and is widely used in sensory studies of food and beverages. Stimulus sensory threshold data It is often used in two research areas. to measure the sensitivity of an assessor or panel of assessors to a specific stimulus, and to test that a substance elicits sensory ability to respond. The former is used to judge the appraiser's evaluation level, and the latter is mainly used as a measure of a certain material property. The term "threshold" was proposed by psychophysicists in the 19th century to indicate the concentration of a stimulus above which the stimulus can be perceived. Below this concentration, it cannot be detected [see Figure 1a)]. a) Threshold for traditional concepts b) Threshold for probabilistic properties Description of index number. X --- stimulating concentration (x); Y --- Perception probability (pd); 1 --- Threshold. Figure 1 Thresholds for traditional concepts and probabilistic properties However, in most cases the relationship between the stimulus concentration and the probability of detection 1) shows an S-shaped curve [Fig. 1b)]. For calculation purposes, A convenient approach is to assume that the threshold fluctuates, and that a particular stimulus concentration may sometimes be above the threshold and sometimes be below it. therefore The threshold value can be obtained by estimating the median of these instantaneous values, that is, the threshold value is the stimulus concentration at which the probability of detection is 0.5.This threshold defines the class It is similar to the definition of the half-effective amount of chemical substances on organisms in pharmacology, toxicology and other disciplines in biology. 1) This document uses the 3-AFC method to test the stimulus, and the detection probability pd=1.5×pc-0.5.where pc is the probability of making the correct choice. strict In general, this is a "guessing model" of the evaluator's behavior, not a psychometric model of the evaluator's judgment process. For example, the signal detection model is also applicable, see Reference [16]. The test results of many laboratories have shown that the detection threshold of a certain substance in water or air can usually range from 2 to 3 or even more. Many orders of magnitude, well beyond the expected experimental errors or differences caused by data processing (see references [10], [13] and [17]). push The reason for the test may be related to the differences in the definition of the threshold or the adoption of different testing procedures in each laboratory. Therefore, Devos et al. proposed a A standardized procedure for detecting detection thresholds in air (see Ref. [10]). When using this document, it should be noted that the determination of the threshold of perception is not a simple description of appearance, and requires a lot of experimental work. Experimental results It shows that the individual threshold of the evaluator tends to decrease and the inter-individual differences tend to decrease after repeated tests. The evaluator measured at the threshold I am not familiar with the test at the beginning of the determination, but with the gradual familiarity with the test samples and inspection procedures, the sensitivity is gradually improved. 3-AFC Method Essentials Ask the rater to identify the stimulus. Although the training procedure is very cumbersome, it will also provide some required information to the experimenter, such as each evaluator's perceived Check the concentration range. When the experimenter understands the perceived concentration range of the individual assessors and provides them with an appropriate concentration range, the test results will be It will be improved, see 6.3. Sensory Analysis Methodology Three-point forced choice (3-AFC) General Guidelines for Smell, Taste, and Flavor Perception Thresholds1 ScopeThis document presents data on olfactory, gustatory and flavor responses to stimuli measured using the three-point forced choice (3-AFC) Guided by processing threshold estimation, error estimation, and other statistical procedures related to detection. The methods given in this document are suitable for either of the following two situations (most experiments can include both of the following situations). a) Determining the sensitivity of assessors to specific stimuli. mainly used in studies of differences in individual sensitivity among individuals or specific groups, and Effects of age, gender, physiological state, disease, drug effects and environmental conditions on sensitivity. b) Detect the characteristics of sensory responses caused by chemical substances, mainly including the following five aspects. ---Research on flavor chemistry and the influence of specific chemical substances on food flavor; --- Classify according to the impact of chemical substances present in the environment on humans; --- Research on the relationship between the molecular structure of chemical substances and their stimulating ability; ---Quality assurance of exhaust gases, water, food and beverages; ---Research on the mechanism of smell. In the above case, since the probability of the assessor making the correct choice changes with the change of stimulus intensity, for the analysis of this change, That is to say, the analysis of the slope of the dose-response (effect) relationship curve is also an important research content besides the threshold measurement. given in this document Information on this is provided in the data processing procedure. The core of this document is the data acquisition and calculation procedures. Regarding the validity of the data, this document only gives general rules and precautions. In this document, no strict distinction is made between "perception threshold" and "difference threshold". In fact, the method given in this document is to determine the difference threshold, that is, by The test sample is compared to the reference sample for threshold measurement. This document does not exclude the inclusion of stimuli in the reference sample at the time of experimental design, or the determination of the reference sample. Whether the sample contains stimuli. The method given in this document is not applicable to the inspection of the "identification threshold" defined in ISO 5492, nor does it involve Standardized methods for air quality determination in EN13725.2 Normative referencesThe contents of the following documents constitute the essential provisions of this document through normative references in the text. Among them, dated references For documents, only the version corresponding to the date is applicable to this document; for undated reference documents, the latest version (including all amendments) is applicable to this document. ISO 5492 Sensory Analysis-Vocabulary Note. GB/T 10221-2021 Sensory Analysis Terminology (ISO 5492.2008, IDT)3 Terms and DefinitionsThe terms and definitions defined in ISO 5492 and the following apply to this document. The terminology databases maintained by ISO and IEC for standardization can be found at the following URLs. ......Tips & Frequently Asked Questions:Question 1: How long will the true-PDF of GB/T 22366-2022_English be delivered?Answer: Upon your order, we will start to translate GB/T 22366-2022_English as soon as possible, and keep you informed of the progress. The lead time is typically 3 ~ 5 working days. The lengthier the document the longer the lead time.Question 2: Can I share the purchased PDF of GB/T 22366-2022_English with my colleagues?Answer: Yes. The purchased PDF of GB/T 22366-2022_English will be deemed to be sold to your employer/organization who actually pays for it, including your colleagues and your employer's intranet.Question 3: Does the price include tax/VAT?Answer: Yes. Our tax invoice, downloaded/delivered in 9 seconds, includes all tax/VAT and complies with 100+ countries' tax regulations (tax exempted in 100+ countries) -- See Avoidance of Double Taxation Agreements (DTAs): List of DTAs signed between Singapore and 100+ countriesQuestion 4: Do you accept my currency other than USD?Answer: Yes. If you need your currency to be printed on the invoice, please write an email to Sales@ChineseStandard.net. In 2 working-hours, we will create a special link for you to pay in any currencies. Otherwise, follow the normal steps: Add to Cart -- Checkout -- Select your currency to pay.Question 5: Should I purchase the latest version GB/T 22366-2022?Answer: Yes. Unless special scenarios such as technical constraints or academic study, you should always prioritize to purchase the latest version GB/T 22366-2022 even if the enforcement date is in future. Complying with the latest version means that, by default, it also complies with all the earlier versions, technically. |
