GB/T 18388-2005 PDF EnglishUS$70.00 · In stock · Download in 9 seconds
GB/T 18388-2005: Electric vehicles -- Engineering approval evaluation program Delivery: 9 seconds. True-PDF full-copy in English & invoice will be downloaded + auto-delivered via email. See step-by-step procedure Status: Valid GB/T 18388: Historical versions
Similar standardsGB/T 18388-2005: Electric vehicles -- Engineering approval evaluation program---This is an excerpt. Full copy of true-PDF in English version (including equations, symbols, images, flow-chart, tables, and figures etc.), auto-downloaded/delivered in 9 seconds, can be purchased online: https://www.ChineseStandard.net/PDF.aspx/GBT18388-2005GB ICS 43.080.01 T 47 NATIONAL STANDARD Replacing GB/T 18388-2001 Electric Vehicles – Engineering Approval Evaluation Program Issued on May 23, 2005 Implemented on October 01, 2005 Issued by General Administration of Quality Supervision, Inspection and Quarantine of the People’s Republic of China Standardization Administration of the People’s Republic of China Table of ContentsForeword... 3 1 Scope... 4 2 Normative References... 4 3 Implementing Conditions... 5 4 Test Items, Test Methods and Basis for Evaluation... 6 5 Test Procedure... 8 6 Test Report... 8 Annex A (Normative) Mandatory Standards... 9ForewordThis Standard replaces GB/T 18388-2001 Electric vehicles - Engineering approval evaluation program. Compared with GB/T 18388-2001, the main changes of this Standard are as follows. — Add the provision - referring to GB 1495-2002 Limits and measurement methods for noise emitted by accelerating motor vehicles, when carrying out noise test emitted by accelerating motor vehicles. (See 4.1.1) — Add the provision - referring to GB 11555-1994 Passenger cars - Windshield demisters - Performance requirements, when carrying out performance test of windshield demisters. (See 4.1.2) — Add the provision - referring to GB 11556-1994 Passenger cars - Windshield defrosters - Performance requirements, when carrying out performance test of windshield defrosters. (See 4.1.3) — Change the driving test content in 4.3.Rearrange the driving mileage. Total driving mileage of reliability driving test is 50% of the total driving mileage of reliability driving that corresponds to engineering approval evaluation program of diesel vehicle. If the total driving mileage is lower than 5000km, perform it as 5000km. In mileage distribution, 35% is bad-road, 65% is flat-road and highway. Annex A of this Standard is normative. This Standard was proposed by National Technical Committee on Road Vehicles of Standardization Administration of China. This Standard shall be under the jurisdiction of National Technical Committee on Road Vehicles of Standardization Administration of China. Drafting organization of this Standard. China Automotive Technology and Research Center. Main drafters of this Standard. Liu Guibin, Chen Song, He Yuntang, and Zhao Ziliang. The previous edition replaced by this Standard. GB/T 18388-2001. Electric Vehicles – Engineering Approval Evaluation Program This standard specifies the implementing conditions, test items, test methods, basis of evaluation, and test reports of new product design and approval evaluation test of pure electric vehicles. This standard is applicable to pure electric vehicles.2 Normative ReferencesThe articles contained in the following documents have become part of this Standard when they are quoted herein. For the dated documents so quoted, all the modifications (excluding corrections) or revisions made thereafter shall not be applicable to this Standard. For the undated documents so quoted, the latest editions shall be applicable to this Standard. GB/T 18384.1 Electric vehicles - Safety specification - Part 1.On-board energy storage GB/T 18384.2 Electric vehicles - Safety specification - Part 2.Functional means and protection against failures GB/T 18384.3 Electric vehicles - Safety specification - Part 3.Protection of persons against electric hazards GB/T 18385 Electric vehicles - Power performance - Test method GB/T 18386 Electric vehicles - Reference energy consumption and range - Test procedures3 Implementing Conditions3.1 The following documents shall be provided before the evaluation. 3.2 The vehicle for evaluation shall conform to requirements of the design drawing and technical documents. 3.3 Quantity of vehicle sample for the engineering approval evaluation. 1. 3.4 After having the above conditions, the manufacturer can apply to relevant department for the engineering approval evaluation. 3.5 During the test process, relevant personnel shall operate and maintain according to provisions specified in the instruction manual. 3.6 After the test is completed, the test organization shall provide the test report according to the contents specified in Chapter 5.4 Test Items, Test Methods and Basis for EvaluationThe test item consists of 3 parts - compulsive standard test, vehicle performance test, and vehicle reliability driving test at test field. 4.1 Compulsive standard test The items of compulsive standard test are shown in Annex A. In which, the 3 test methods - vehicle external noise, windscreen defrosting, and windscreen demisting are shown in Clause 4.1.1 ~ 4.1.3. 4.1.1 The external noise test of electric vehicle shall be carried out under the electric mode. And the test methods shall be reference to GB 1495-2002 Vehicle Acceleration Running External Noise Limit and Measuring Method. At the same time, make the changes as follows. 4.1.2 When conducting the test of windscreen demisting system of electric vehicle, the test shall be reference to GB 11555–1994 Performance Requirements and Test methods of Vehicle Windscreen Demisting System. It only requires to turn on the main circuit switch. The power motor is not required to run. 4.2 Vehicle performance test Vehicle performance test of electric vehicle shall be performed at the test field authorized by the State. The test items will be evaluated according to the product technical specifications. 4.2.1 Measurement of basic parameters and main performance parameters of the vehicle 4.2.2 Special performance test of electric vehicle 4.3 Reliability driving test The Reliability driving test of electric vehicle shall be carried out at the test field authorized by the State. 4.3.1 Total driving mileage of reliability driving test is 50% of the total driving mileage that corresponds to approval evaluation program of diesel vehicle. If the total driving mileage is lower than 5000km, perform it as 5000km. 4.3.2 The mileage distribution of vehicle is that 35% is bad-road; 65% is flat-road and highway.5 Test Procedure5.1 Receive the sample vehicles for inspection and test. Register the sample vehicles. 5.2 Run-in the vehicle in according to the manufacturer’s specifications. 5.4 Compile the test report.6 Test ReportTest report shall include following contents.Annex A(Normative) Mandatory Standards The articles contained in the following documents have become part of this Standard when they are quoted herein. For the dated documents so quoted, all the modifications (excluding corrections) or revisions made thereafter shall not be applicable to this Standard. For the undated documents so quoted, the latest editions shall be applicable to this Standard. ......Source: Above contents are excerpted from the full-copy PDF -- translated/reviewed by: www.ChineseStandard.net / Wayne Zheng et al. Tips & Frequently Asked Questions:Question 1: How long will the true-PDF of English version of GB/T 18388-2005 be delivered?Answer: The full copy PDF of English version of GB/T 18388-2005 can be downloaded in 9 seconds, and it will also be emailed to you in 9 seconds (double mechanisms to ensure the delivery reliably), with PDF-invoice.Question 2: Can I share the purchased PDF of GB/T 18388-2005_English with my colleagues?Answer: Yes. The purchased PDF of GB/T 18388-2005_English will be deemed to be sold to your employer/organization who actually paid for it, including your colleagues and your employer's intranet.Question 3: Does the price include tax/VAT?Answer: Yes. Our tax invoice, downloaded/delivered in 9 seconds, includes all tax/VAT and complies with 100+ countries' tax regulations (tax exempted in 100+ countries) -- See Avoidance of Double Taxation Agreements (DTAs): List of DTAs signed between Singapore and 100+ countriesQuestion 4: Do you accept my currency other than USD?Answer: Yes. www.ChineseStandard.us -- GB/T 18388-2005 -- Click this link and select your country/currency to pay, the exact amount in your currency will be printed on the invoice. Full PDF will also be downloaded/emailed in 9 seconds.Question 5: Should I purchase the latest version GB/T 18388-2005?Answer: Yes. Unless special scenarios such as technical constraints or academic study, you should always prioritize to purchase the latest version GB/T 18388-2005 even if the enforcement date is in future. Complying with the latest version means that, by default, it also complies with all the earlier versions, technically.How to buy and download a true PDF of English version of GB/T 18388-2005?A step-by-step guide to download PDF of GB/T 18388-2005_EnglishStep 1: Visit website https://www.ChineseStandard.net (Pay in USD), or https://www.ChineseStandard.us (Pay in any currencies such as Euro, KRW, JPY, AUD).Step 2: Search keyword "GB/T 18388-2005". Step 3: Click "Add to Cart". If multiple PDFs are required, repeat steps 2 and 3 to add up to 12 PDFs to cart. Step 4: Select payment option (Via payment agents Stripe or PayPal). Step 5: Customize Tax Invoice -- Fill up your email etc. Step 6: Click "Checkout". Step 7: Make payment by credit card, PayPal, Google Pay etc. After the payment is completed and in 9 seconds, you will receive 2 emails attached with the purchased PDFs and PDF-invoice, respectively. Step 8: Optional -- Go to download PDF. Step 9: Optional -- Click Open/Download PDF to download PDFs and invoice. See screenshots for above steps: Steps 1~3 Steps 4~6 Step 7 Step 8 Step 9 |
