GB 1886.325-2021 PDF English
US$80.00 · In stock · Download in 9 secondsGB 1886.325-2021: National food safety standard - Food additives - Potassium polymetaphosphate Delivery: 9 seconds. True-PDF full-copy in English & invoice will be downloaded + auto-delivered via email. See step-by-step procedureStatus: Valid
| Standard ID | Contents [version] | USD | STEP2 | [PDF] delivery | Name of Chinese Standard | Status |
| GB 1886.325-2021 | English | 80 |
Add to Cart
|
0-9 seconds. Auto-delivery
|
National food safety standard - Food additives - Potassium polymetaphosphate
| Valid |
Excerpted PDFs (Download full copy in 9 seconds upon purchase)PDF Preview: GB 1886.325-2021
GB 1886.325-2021: National food safety standard - Food additives - Potassium polymetaphosphate---This is an excerpt. Full copy of true-PDF in English version (including equations, symbols, images, flow-chart, tables, and figures etc.), auto-downloaded/delivered in 9 seconds, can be purchased online: https://www.ChineseStandard.net/PDF.aspx/GB1886.325-2021
GB
NATIONAL STANDARD OF THE
PEOPLE’S REPUBLIC OF CHINA
National food safety standard - Food additives -
Potassium polymetaphosphate
ISSUED ON: FEBRUARY 22, 2021
IMPLEMENTED ON: AUGUST 22, 2021
Issued by: National Health Commission of the People's Republic of
China;
State Administration for Market Regulation.
Table of Contents
1 Scope ... 3
2 Molecular formula and relative molecular mass ... 3
3 Technical requirements ... 3
Appendix A Inspection method ... 5
National food safety standard - Food additives -
Potassium polymetaphosphate
1 Scope
This Standard applies to the food additive potassium polymetaphosphate which
is made by high-temperature dehydration polymerization, with monopotassium
phosphate as the raw material.
2 Molecular formula and relative molecular mass
2.1 Molecular formula
(KPO3)n
2.2 Relative molecular mass
118.069n (according to the international relative atomic mass in 2018)
3 Technical requirements
3.1 Sensory requirements
Sensory requirements shall be in accordance with Table 1.
3.2 Physical and chemical indicators
Physical and chemical indicators shall be in accordance with Table 2.
Table 2 – Physical and chemical indicators
Appendix A
Inspection method
WARNING: Some reagents used in this test method are toxic or corrosive;
the operator shall be careful. If it is splashed on the skin, use water to
rinse it immediately. If it is serious, seek medical attention immediately.
A.1 General Provisions
The reagents and water that are used in this Standard, when no other
requirements are specified, refer to analytical reagents and grade-III water
which is specified in GB/T 6682. The standard solution, the standard solutions,
preparations and products for impurity determination, which are used in the test,
are all prepared in accordance with the provisions of GB/T 601, GB/T 602, and
GB/T 603, when no other requirements are specified. The solution used in the
test, if not indicated which solvent is used, refers to aqueous solution.
A.2 Identification test
A.2.1 Reagents and materials
A.2.1.1 Hydrochloric acid.
A.2.1.2 Silver nitrate solution: 17 g/L.
A.2.1.3 Ammonia solution: 2+3.
A.2.1.4 Nitric acid solution: 1+9.
A.2.1.5 Sodium acetate solution: 40 g/L.
A.2.2 Identification method
A.2.2.1 Identification of potassium ions
Weigh 0.1 g of the sample and dissolve it in 10 mL of water. Dip the platinum
wire in hydrochloric acid; burn it on the flame until it is colorless; then, dip the
sample solution and burn it on the flame; observe that the flame is purple under
the cobalt glass.
A.2.2.2 Identification of phosphate
Weigh 1 g of the sample; dissolve it in 20 mL of water; add silver nitrate solution,
to produce a yellow precipitate. This precipitate is soluble in ammonia solution
or nitric acid solution.
again; continue to boil until the precipitate stratifies; cool to room temperature.
Use a crucible that has been dried to constant weight at 180 °C ± 2 °C for
filtration; filter the supernatant first; use water to rinse the precipitate and filter
6 times (about 30 mL of water each time); move the precipitate into the crucible;
then, use water to rinse the precipitate 4 times; put the precipitate together with
the crucible in a drying box; take it out after drying at 180 °C for 45 minutes;
cool it to room temperature in a desiccator; weigh it. Use 10 mL of water instead
of the sample solution, to do a blank test at the same time.
A.3.5 Result calculation
Calculate the mass fraction w1 of phosphorus pentoxide (P2O5) (on a dry basis)
according to Formula (A.1).
Where:
m1 – the mass of quinoline phosphomolybdate precipitate that is formed by the
test solution, in grams (g);
m2 – the mass of quinoline phosphomolybdate precipitate that is formed by the
blank solution, in grams (g);
0.032 07 – the coefficient of conversion of quinoline phosphomolybdate to
phosphorus pentoxide (P2O5);
500 – the initial volume of the sample solution, in milliliters (mL);
m – the mass of the dried sample, in grams (g);
10 – the measured volume of the sample solution, in milliliters (mL).
The test result is based on the arithmetic mean of the parallel determination
results. The absolute difference between two independent determination results
that are obtained under repeatability conditions is not more than 0.3%.
A.4 Determination of loss on ignition (on a dry basis)
A.4.1 Instruments and apparatuses
A.4.1.1 Crucible.
A.4.1.2 Electrothermal constant-temperature dry box.
A.4.1.3 High temperature furnace.
......
Source: Above contents are excerpted from the full-copy PDF -- translated/reviewed by: www.ChineseStandard.net / Wayne Zheng et al.
Tips & Frequently Asked QuestionsQuestion 1: How long will the true-PDF of English version of GB 1886.325-2021 be delivered?Answer: The full copy PDF of English version of GB 1886.325-2021 can be downloaded in 9 seconds, and it will also be emailed to you in 9 seconds (double mechanisms to ensure the delivery reliably), with PDF-invoice. Question 2: Can I share the purchased PDF of GB 1886.325-2021_English with my colleagues?Answer: Yes. The purchased PDF of GB 1886.325-2021_English will be deemed to be sold to your employer/organization who actually paid for it, including your colleagues and your employer's intranet. Question 3: Does the price include tax/VAT?Answer: Yes. Our tax invoice, downloaded/delivered in 9 seconds, includes all tax/VAT and complies with 100+ countries' tax regulations (tax exempted in 100+ countries) -- See Avoidance of Double Taxation Agreements (DTAs): List of DTAs signed between Singapore and 100+ countriesQuestion 4: Do you accept my currency other than USD?Answer: Yes. www.ChineseStandard.us -- GB 1886.325-2021 -- Click this link and select your country/currency to pay, the exact amount in your currency will be printed on the invoice. Full PDF will also be downloaded/emailed in 9 seconds. How to buy and download a true PDF of English version of GB 1886.325-2021?A step-by-step guide to download PDF of GB 1886.325-2021_EnglishStep 1: Visit website https://www.ChineseStandard.net (Pay in USD), or https://www.ChineseStandard.us (Pay in any currencies such as Euro, KRW, JPY, AUD).
Step 2: Search keyword "GB 1886.325-2021".
Step 3: Click "Add to Cart". If multiple PDFs are required, repeat steps 2 and 3 to add up to 12 PDFs to cart.
Step 4: Select payment option (Via payment agents Stripe or PayPal).
Step 5: Customize Tax Invoice -- Fill up your email etc.
Step 6: Click "Checkout".
Step 7: Make payment by credit card, PayPal, Google Pay etc. After the payment is completed and in 9 seconds, you will receive 2 emails attached with the purchased PDFs and PDF-invoice, respectively.
Step 8: Optional -- Go to download PDF.
Step 9: Optional -- Click Open/Download PDF to download PDFs and invoice.
See screenshots for above steps: Steps 1~3 Steps 4~6 Step 7 Step 8 Step 9
|