GB/T 27652-2011 English PDFUS$139.00 · In stock
Delivery: <= 3 days. True-PDF full-copy in English will be manually translated and delivered via email. GB/T 27652-2011: Methods of pretreatment for chemical analysis of preservative-treated wood Status: Valid
Basic dataStandard ID: GB/T 27652-2011 (GB/T27652-2011)Description (Translated English): Methods of pretreatment for chemical analysis of preservative-treated wood Sector / Industry: National Standard (Recommended) Classification of Chinese Standard: B71 Classification of International Standard: 79-010 Word Count Estimation: 6,650 Date of Issue: 2011-12-30 Date of Implementation: 2012-04-01 Quoted Standard: GB/T 1933 Regulation (derived from): Announcement of Newly Approved National Standards No. 22 of 2011 Issuing agency(ies): General Administration of Quality Supervision, Inspection and Quarantine of the People's Republic of China, Standardization Administration of the People's Republic of China Summary: This standard specifies the chemical analysis of wood preservative pretreatment of four ways: Hydrogen peroxide nitric acid digestion method, perchloric acid digestion method, microwave nitric acid digestion and hydrogen peroxide sulfuric acid bath method. This standard applies to the analysis of wood preservative arsenic, chromium, copper, phosphate pretreatment active ingredient content. Among them, microwave nitric acid digestion and hydrogen peroxide sulfuric acid bath method is suitable for atomic absorption spectroscopy, inductively coupled plasma atomic emission spectroscopy and atomic fluorescence spectrometer wood preservative active ingredient in the analysis of pretreatment. GB/T 27652-2011: Methods of pretreatment for chemical analysis of preservative-treated wood---This is a DRAFT version for illustration, not a final translation. Full copy of true-PDF in English version (including equations, symbols, images, flow-chart, tables, and figures etc.) will be manually/carefully translated upon your order.Methods of pretreatment for chemical analysis of preservative-treated wood ICS 79-010 B71 National Standards of People's Republic of China Wood preservative chemical pretreatment prior to analysis Issued on. 2011-12-30 2012-04-01 implementation Administration of Quality Supervision, Inspection and Quarantine of People's Republic of China Standardization Administration of China released ForewordThe standard reference American wood preservative association AWPA Standard A7-05 "Wood chemical analysis before ashing procedures" and Australia AS/NZS1605.2006 "wood preservatives and sampling and analytical methods embalmed material" to develop. This standard was proposed by the State Forestry Administration. This standard by the National Standardization Technical Committee timber. This standard is drafted by. Guangdong Provincial Academy of Forestry. Participated in the drafting of this standard. Guangdong Provincial Forest Products Quality Supervision, Inspection Station, the State Forestry Administration Forest Products Quality Inspection and Testing Center (Guangzhou). The main drafters of this standard. Chen Lifang, Zhang Yanjun, Su Haitao, Xiegui Jun, ranking Solutions Language, Li Xingwei. Wood preservative chemical pretreatment prior to analysis1 ScopeThis standard specifies four methods for chemical analysis of wood preservative before pretreatment. hydrogen peroxide - nitric acid digestion method, perchloric acid digestion, micro Wave - nitric acid digestion and hydrogen peroxide - dilute sulfuric acid water bath method. This standard applies to the analysis of pre-treatment of wood preservative active ingredient content of arsenic, chromium, copper, phosphate and the like. Wherein the microwave - nitric acid digestion Law and hydrogen peroxide - sulfuric acid in a water bath method is suitable for atomic absorption spectrometry, inductively coupled plasma emission spectroscopy and atomic fluorescence spectrometer In the analysis of pretreatment wood preservative active ingredient ago.2 Normative referencesThe following documents contain provisions which, through reference in this standard and become the standard terms. For dated references, subsequent Amendments (not including errata content) or revisions do not apply to this standard, however, encourage the parties to the agreement are based on research Whether the latest versions of these documents. For undated reference documents, the latest versions apply to this standard. GB/T 1933 Wood Density Determination Preparation 3 wood flour samples 3.1 Sampling Wood preservative test samples shall be taken from a representative sample from the timber tip 300mm or more, the sampling site should avoid knots, open And stress cracking wood. After determining the location, take the middle section of the cross section of wood or wood with hollow drill to drill wood core. 3.2 Determination of the density of wood preservative Determination of the density of the wood samples by the method of GB/T 1933 regulations. 3.3 sample preparation Crusher plants will get 3.1 wood preservative pulverized sample, taken through a 30 mesh standard sieve flour, baking at about 125 ℃ 2.5h to constant weight. 4 hydrogen peroxide - nitric acid digestion method 4.1 instruments and equipment Analytical balance (0.1mg), temperature controlled electric heating plate, 250mL or 500mL Kjeldahl flask, 100mL or 200mL volumetric flask. 4.2 Reagents Concentrated nitric acid (70% AR), hydrogen peroxide solution (30% AR). 4.3 process Accurately weigh about 5g (accurate to 0.1mg) by 3.3 prepared flour sample was placed in 250mL or 500mL Kjeldahl flask, bottle along Concentrated nitric acid was slowly added wall 75mL fully wetted wood flour (wood flour equivalent per gram of sample was added 15mL of concentrated nitric acid), then add 3 to 5 Glass beads, a temperature-controlled flask was then placed on a hot plate heated slowly. After the initial formation of brown smoke reaction, heating was continued until the solution becomes clear and transparent. Cool, was added dropwise 5mL peroxide Hydrogen solution. If the treatment solution after digestion less than the above-described clear, 5mL was added dropwise hydrogen peroxide solution, heating was continued until the solution Clear. Depending on how much of the alleged mass sample digestion will be fully transferred to 100mL or 200mL volumetric flask, and diluted with distilled water Volume. Prepare a 250mL or 500mL empty Kjeldahl flask, with an equal amount of flour sample above digested acids and other reagents, ......Tips & Frequently Asked Questions:Question 1: How long will the true-PDF of GB/T 27652-2011_English be delivered?Answer: Upon your order, we will start to translate GB/T 27652-2011_English as soon as possible, and keep you informed of the progress. The lead time is typically 1 ~ 3 working days. The lengthier the document the longer the lead time.Question 2: Can I share the purchased PDF of GB/T 27652-2011_English with my colleagues?Answer: Yes. The purchased PDF of GB/T 27652-2011_English will be deemed to be sold to your employer/organization who actually pays for it, including your colleagues and your employer's intranet.Question 3: Does the price include tax/VAT?Answer: Yes. Our tax invoice, downloaded/delivered in 9 seconds, includes all tax/VAT and complies with 100+ countries' tax regulations (tax exempted in 100+ countries) -- See Avoidance of Double Taxation Agreements (DTAs): List of DTAs signed between Singapore and 100+ countriesQuestion 4: Do you accept my currency other than USD?Answer: Yes. If you need your currency to be printed on the invoice, please write an email to Sales@ChineseStandard.net. In 2 working-hours, we will create a special link for you to pay in any currencies. Otherwise, follow the normal steps: Add to Cart -- Checkout -- Select your currency to pay. |
