GB 1886.334-2021 PDF EnglishUS$125.00 · In stock · Download in 9 seconds
GB 1886.334-2021: National food safety standard - Food additives - Dipotassium hydrogen phosphate Delivery: 9 seconds. True-PDF full-copy in English & invoice will be downloaded + auto-delivered via email. See step-by-step procedure Status: Valid
Similar standardsGB 1886.334-2021: National food safety standard - Food additives - Dipotassium hydrogen phosphate---This is an excerpt. Full copy of true-PDF in English version (including equations, symbols, images, flow-chart, tables, and figures etc.), auto-downloaded/delivered in 9 seconds, can be purchased online: https://www.ChineseStandard.net/PDF.aspx/GB1886.334-2021GB NATIONAL STANDARD OF THE PEOPLE’S REPUBLIC OF CHINA National Food Safety Standard - Food Additives - Dipotassium Hydrogen Phosphate ISSUED ON: FEBRUARY 22, 2021 IMPLEMENTED ON: AUGUST 22, 2021 Issued by: National Health Commission of the People’s Republic of China; State Administration for Market Regulation. Table of ContentsForeword ... 3 1 Scope ... 4 2 Molecular Formula and Relative Molecular Mass ... 4 3 Technical Requirements ... 4 Appendix A Inspection Methods ... 6 National Food Safety Standard - Food Additives - Dipotassium Hydrogen Phosphate1 ScopeThis Standard is applicable to the food additive dipotassium hydrogen phosphate produced with potassium hydroxide and food additive phosphoric acid (including wet- process phosphoric acid) as raw materials.2 Molecular Formula and Relative Molecular Mass2.1 Molecular formula Dipotassium hydrogen phosphate anhydrous: K2HPO4 Dipotassium hydrogen phosphate trihydrate: K2HPO4 • 3H2O 2.2 Relative Molecular Mass Dipotassium hydrogen phosphate anhydrous: 174.17 (as per 2018 international atomic mass) Dipotassium hydrogen phosphate trihydrate: 228.22 (as per 2018 international atomic mass)3 Technical Requirements3.1 Sensory requirements The sensory requirements shall comply with the provisions of Table 1. Table 1 – Sensory Requirements 3.2 Physicochemical indexAppendix AInspection Methods Caution: Some reagents used in this test method are toxic or corrosive, so please be careful to take appropriate safety and protection measures when operating! If necessary, perform it in a fume hood. If it splashes on the skin, it shall be rinsed with water immediately, and the severe cases shall be treated immediately. A.1 General provisions If no other requirements are specified, all the reagents and water used in this Standard refer to the analytical reagents and Class-III water specified in GB/T 6682. If no other requirements are specified, standard solution for determining the impurity, preparation and product used in the test shall be prepared according to the provisions of GB/T 601, GB/T 602, GB/T 603.The solution used in the test refers to the aqueous solution when the solvent is not specified. A.2 Identification test A.2.1 Reagents and materials A.2.1.1 Nitric acid solution: 1+8. A.2.1.2 Ammonia solution: 2+3. A.2.1.3 Silver nitrate solution: 17g/L. A.2.2 Identification method A.2.2.1 Identification of phosphate radical Weigh about 1.0g of specimen; dissolve it in 20mL of water; adjust to neutral with nitric acid solution. Add silver nitrate solution to produce yellow precipitate, which is soluble in ammonia solution or nitric acid solution. A.2.2.2 Identification of potassium ions Weigh 1g of specimen; add 20mL of water to dissolve. Dip a platinum wire ring in hydrochloric acid and burn it to colourless on the flame. Dip the test solution and burn it on the flame. The flame shall be purple when viewed with cobalt glass. A.3 Determination of the content of dipotassium hydrogen phosphate (K2HPO4) (on a dry basis) Where: 40.0 – volume of the added hydrochloric acid standard titration solution, in mL; c1 – concentration of hydrochloric acid standard titration solution, in mol/L; V – volume of sodium hydroxide standard titration solution consumed for titration till a sudden jump point occurs at pH≈4.0, in mL; c2 – concentration of sodium hydroxide standard titration solution, in mol/L. When , the mass fraction of dipotassium hydrogen phosphate (by K2HPO4 • 3H2O or K2HPO4) w1 shall be calculated according to Formula (A.2). When , the mass fraction of dipotassium hydrogen phosphate (by K2HPO4 • 3H2O or K2HPO4) w1 shall be calculated according to Formula (A.3). Where: V1 – when titrating till a sudden jump point occurs at pH≈4.0, volume of hydrochloric acid standard titration solution consumed by the specimen, in mL; c1 – concentration of hydrochloric acid standard titration solution, in mol/L; M – molar mass of dipotassium hydrogen phosphate (by K2HPO4), in g/mol (M=174.17); 10-3 – conversion factor; m1 – mass of specimen, in g; V2 – volume of sodium hydroxide standard titration solution consumed for titration at pH≈4.0 to pH≈8.8, in mL; c2 – concentration of sodium hydroxide standard titration solution, in mol/L. The test results are based on the arithmetic mean of the parallel determination results. The absolute difference between two independent determination results obtained under repeatability conditions is no more than 0.2%. A.4 Determination of loss on drying mL of water and heat it to a boil. While it is hot, filter by the glass sand crucible pre- baked in an electric heating constant temperature drying oven at 105°C±2°C. Wash the water-insoluble matter for 10 times by 200mL of hot water. Put the glass sand crucible together with the water-insoluble matter in a 105°C±2°C electric heating constant temperature drying box until the mass is constant. A.5.3 Calculation of results The mass fraction w3 of water-insoluble matter is calculated according to Formula (A.5). Where: m4 – mass of water-insoluble matter and glass sand crucible, in g; m5 – mass of glass sand crucible, in g; m6 – mass of specimen, in g; w2 – mass fraction of loss on drying measured according to A.4, in %. The test results are based on the arithmetic mean of the parallel determination results. The absolute difference between two independent determination results obtained under repeatability conditions is no more than 0.002%. A.6 Determination of pH (10g/L aqueous solution) A.6.1 Reagents and materials Carbon dioxide-free water. A.6.2 Apparatus Acidity meter: Resolution of 0.01pH, equipped with glass electrode and saturated calomel electrode (or composite electrode). A.6.3 Analysis procedures Weigh 1.00g±0.01g of specimen; place it in a 100mL beaker; dissolve it with carbon dioxide-free water; transfer it into a 100mL volumetric flask. Dilute to the mark with carbon dioxide-free water; and shake it well. Pour into a 100mL dry beaker; and measure the pH of the specimen solution with a calibrated acidity meter. The test results are based on the arithmetic mean of the parallel determination results. The absolute difference between two independent determination results obtained under repeatability conditions is no more than 0.1%. ......Source: Above contents are excerpted from the full-copy PDF -- translated/reviewed by: www.ChineseStandard.net / Wayne Zheng et al. Tips & Frequently Asked Questions:Question 1: How long will the true-PDF of English version of GB 1886.334-2021 be delivered?Answer: The full copy PDF of English version of GB 1886.334-2021 can be downloaded in 9 seconds, and it will also be emailed to you in 9 seconds (double mechanisms to ensure the delivery reliably), with PDF-invoice.Question 2: Can I share the purchased PDF of GB 1886.334-2021_English with my colleagues?Answer: Yes. The purchased PDF of GB 1886.334-2021_English will be deemed to be sold to your employer/organization who actually paid for it, including your colleagues and your employer's intranet.Question 3: Does the price include tax/VAT?Answer: Yes. Our tax invoice, downloaded/delivered in 9 seconds, includes all tax/VAT and complies with 100+ countries' tax regulations (tax exempted in 100+ countries) -- See Avoidance of Double Taxation Agreements (DTAs): List of DTAs signed between Singapore and 100+ countriesQuestion 4: Do you accept my currency other than USD?Answer: Yes. www.ChineseStandard.us -- GB 1886.334-2021 -- Click this link and select your country/currency to pay, the exact amount in your currency will be printed on the invoice. Full PDF will also be downloaded/emailed in 9 seconds.How to buy and download a true PDF of English version of GB 1886.334-2021?A step-by-step guide to download PDF of GB 1886.334-2021_EnglishStep 1: Visit website https://www.ChineseStandard.net (Pay in USD), or https://www.ChineseStandard.us (Pay in any currencies such as Euro, KRW, JPY, AUD).Step 2: Search keyword "GB 1886.334-2021". Step 3: Click "Add to Cart". If multiple PDFs are required, repeat steps 2 and 3 to add up to 12 PDFs to cart. Step 4: Select payment option (Via payment agents Stripe or PayPal). Step 5: Customize Tax Invoice -- Fill up your email etc. Step 6: Click "Checkout". Step 7: Make payment by credit card, PayPal, Google Pay etc. After the payment is completed and in 9 seconds, you will receive 2 emails attached with the purchased PDFs and PDF-invoice, respectively. Step 8: Optional -- Go to download PDF. Step 9: Optional -- Click Open/Download PDF to download PDFs and invoice. See screenshots for above steps: Steps 1~3 Steps 4~6 Step 7 Step 8 Step 9 |
