GB 19641-2015 (GB19641-2015) & related versions
Buy with any currencies (Euro, JPY, KRW...): GB 19641-2015 Preview this PDF: GB 19641-2015
GB 19641-2015
GB
NATIONAL STANDARD OF THE
PEOPLE’S REPUBLIC OF CHINA
National Food Safety Standard - Oil Seeds
ISSUED ON: NOVEMBER 13, 2015
IMPLEMENTED ON: NOVEMBER 13, 2016
Issued by: National Health and Family Planning Commission of the People’s
Republic of China
Table of Contents
Foreword ... 3
1 Scope ... 4
2 Terms and Definitions ... 4
3 Technical Requirements ... 4
4 Others ... 5
Appendix A Inspection Method for Datura Seeds ... 6
Appendix B Inspection Method for Ergot ... 9
Bibliography ... 11
National Food Safety Standard - Oil Seeds
1 Scope
This document is applicable to oil seeds for making edible vegetable oil.
2 Terms and Definitions
2.1 Moldy Kernels
Moldy kernels refer to kernels whose surface is obviously moldy and damages the embryo,
endosperm or cotyledon, and has no edible value.
3 Technical Requirements
3.1 Sensory Requirements
The sensory requirements shall comply with the stipulations of Table 1.
3.2 Limits of Poisonous and Harmful Fungi and Plant Seeds
The limits of poisonous and harmful fungi and plant seeds shall comply with the stipulations of
Table 2.
A.1.2 Identification
Those that comply with the above description of morphological characteristics in A.1.1 can be
identified as the datura.
A.2 Alkaloid Colorimetric Characterization
A.2.1 Principle
Atropine and other alkaloids contained in the specimen have a chromogenic reaction with
fuming nitric acid and potassium hydroxide solution after extraction.
A.2.2 Reagents
A.2.2.1 Ammonia water (1 + 1).
A.2.2.2 Diethyl ether.
A.2.2.3 Hydrochloric acid (1 + 5).
A.2.2.4 Chloroform.
A.2.2.5 Anhydrous sodium sulfate.
A.2.2.6 Fuming nitric acid.
A.2.2.7 Potassium hydroxide - ethanol solution (100 g/L).
A.2.3 Analytical procedures
Put about 30 datura seeds into a mortar, add ammonia water (1 + 1) to soak them for a while,
then, grind them into a viscous shape; add diethyl ether and grind it for three times, 10 mL each
time; combine the diethyl ether in a separatory funnel, add 10 mL of hydrochloric acid (1 + 5),
shake and extract it for 1 min, then, separate the hydrochloric acid layer into another separatory
funnel. Add ammonia water (1 + 1) to make it alkaline and use 10 mL of chloroform to shake
and extract it for 1 min, then, extract again, combine the chloroform layer; through anhydrous
sodium sulfate, dehydrate it and concentrate to 0.5 mL; reserve it for later use.
Take 0.2 mL of test solution in a small evaporating dish, evaporate the solvent to dryness, then,
add 4 drops of fuming nitric acid to dissolve the residue; on a water bath, evaporate it to dryness,
and the residue turns yellow. After cooling, add several drops of potassium hydroxide - ethanol
solution (100 g/L), then, it will turn corydalis, and then, red. Atropine, hyoscyamine and
scopolamine all react in this way.
A.3 Thin Layer Chromatographic Characterization
A.3.1 Principle
After atropine and other alkaloids contained in the specimen are extracted, use thin layer to
separate it, then, use a color developing agent to perform color development and compare it
with the reference standard.
A.3.2 Reagents
A.3.2.1 Silica gel G thin-layer plate: thickness 0.3 mm ~ 0.5 mm, activate at 105 C for 1 h,
then, put in a desiccator and reserve it for later use.
A.3.2.2 Developing solvent: methanol - ammonia water (200 + 3).
A.3.2.3 Color developing agent: weigh-take 0.85 g of bismuth subnitrate, add 10 mL of glacial
acetic acid and add 40 mL of water to dissolve it. Take 5 mL, add 5 mL of potassium iodide
solution (4 g potassium iodide dissolved in 5 mL of water), then, add 20 mL of glacial acetic
acid, add water to dilute to 100 mL.
A.3.2.4 Atropine standard solution: weigh-take 120.0 mg of atropine sulfate, dissolve it in 10
mL of water; add ammonia water (1 + 1) to make it alkaline, use chloroform to extract it twice,
8 mL each time. Through a little anhydrous sodium sulfate, dehydrate the chloroform extract
and filter it into a 20 mL colorimetric tube with a stopper. Then, use a little chloroform to wash
the filter and incorporate the washing solution into the colorimetric tube. Add chloroform to 20
mL, and each milliliter of this solution is equivalent to 5.0 mg of atropine.
A.3.2.5 Scopolamine standard solution: weigh-take 145.0 mg of scopolamine hydrobromide,
dissolve it in 10 mL of water, add ammonia water (1 + 1) to make it alkaline, then, use
chloroform to extract it twice, 8 mL each time. Through a little anhydrous sodium sulfate,
dehydrate the chloroform extract and filter it into a 20 mL colorimetric tube with a stopper.
Then, use a little chloroform to wash the filter and incorporate the washing solution into the
colorimetric tube. Add chloroform to 20 mL, and each milliliter of this solution is equivalent to
5.0 mg of scopolamine.
A.3.3 Analytical procedures
At 2 cm from the lower end of the thin-layer plate, spot 10 L of standard solutions of atropine
and scopolamine, 30 L ~ 100 L of specimen extraction concentrate, with a distance of 1.5
cm between each spot. Place it in a developing tank saturated with developing solvent in
advance, and wait until the front of the solvent reaches 10 cm ~ 15 cm, then, take it out and
evaporate the developing agent; spray the color developing agent to manifest orange-red spots,
which is a positive reaction.
Appendix B
Inspection Method for Ergot
B.1 Identification
B.1.1 Morphological characteristics
Ergot is elongated or banana-shaped, sometimes slightly flat, 3 mm ~ 10 mm long, 1 mm ~ 7
mm thick, black or purple-black on the outside, with longitudinal grooves and transverse cracks,
brittle, easy to break, flat cross-section, blunt polygonal or oval, and the center is white, off-
white or pinkish-white. After dormancy, sclerotium germinates to generate stroma; infertile
stromata stalks are slender, with an oblate spherical head, 1 mm ~ 2 mm in diameter, reddish
brown and with perithecium grown on the outer edge.
B.1.2 Tissue sections
Soak the ergot in water for 24 h to make it swell; sandwich it between potatoes or radishes to
fix it, and use a small scalpel to cut it into slices as thin as possible. Use methylene blue solution
(1 g/L) to develop color and observe under the microscope, its tissue is compact.
B.2 Sclerethryrin and Ergot Alkaloids Characterization
B.2.1 Reagents
B.2.1.1 Tartaric acid solution (20 g/L).
B.2.1.2 Anhydrous ether.
B.2.1.3 Saturated sodium bicarbonate solution.
B.2.1.4 Ammonia water (1 + 1).
B.2.1.5 Chloroform.
B.2.1.6 Para-dimethylaminobenzaldehyde solution: weigh-take 0.125 g of para-
dimethylaminobenzaldehyde, add 100 mL of diluted sulfuric acid (slowly pour 65 mL of
sulfuric acid into 35 mL of water, mix it well and cool it) to dissolve it, then, add 0.1 mL of
ferric chloride solution (50 g/L) and mix it well.
B.2.1.7 Absolute ethanol: there is no fluorescence when observed under the ultraviolet light
with a wavelength of 365 nm.
B.2.2 Analytical procedures
Take 20 suspected ergots in a mortar, grind them and add tartaric acid solution (20 g/L) to grind
into a viscous shape; add diethyl ether and carefully grind for three times, 10 mL each time;
......
Standard ID | GB 19641-2015 (GB19641-2015) | Description (Translated English) | National food safety standard -- Oil seeds | Sector / Industry | National Standard | Classification of Chinese Standard | X09 | Classification of International Standard | 67.040 | Word Count Estimation | 10,124 | Date of Issue | 2015-11-13 | Date of Implementation | 2016-11-13 | Older Standard (superseded by this standard) | GB 19641-2005 | Regulation (derived from) | National Health and Family Planning Commission Announcement No | Issuing agency(ies) | National Health and Family Planning Commission of the People's Republic of China | Standard ID | GB 19641-2005 (GB19641-2005) | Description (Translated English) | Hygienic standard for oil seeds | Sector / Industry | National Standard | Classification of Chinese Standard | C53 | Classification of International Standard | 67.040 | Word Count Estimation | 5,580 | Date of Issue | 2005-01-25 | Date of Implementation | 2005-10-01 | Quoted Standard | GB 2763; GB/T 5009.11; GB/T 5009.12; GB/T 5009.22; GB/T 5009.36; GB/T 5494 | Drafting Organization | Shanghai Municipal Health Bureau Health Authority | Administrative Organization | Ministry of Health | Regulation (derived from) | Announcement of Newly Approved National Standards No. 3, 2005 (No. 77 overall) | Proposing organization | Ministry of Health of the People Republic of China | Issuing agency(ies) | The People Republic of China Ministry of Health, China National Standardization Management Committee | Summary | This Chinese standard specifies the required preparation of vegetable oil plant oil health indicators and test methods, packaging, labeling, storage, transport hygiene requirements. This standard applies to the preparation of vegetable oil fuel. |
|