HJ/T 56-2000 PDF English
US$85.00 · In stock · Download in 9 secondsHJ/T 56-2000: Determination of sulphur dioxide from exhausted gas of stationary source - Iodine titration method Delivery: 9 seconds. True-PDF full-copy in English & invoice will be downloaded + auto-delivered via email. See step-by-step procedure
| Standard ID | Contents [version] | USD | STEP2 | [PDF] delivery | Name of Chinese Standard | Status |
| HJ/T 56-2000 | English | 85 |
Add to Cart
|
0-9 seconds. Auto-delivery
|
Determination of sulphur dioxide from exhausted gas of stationary source - Iodine titration method
| |
Excerpted PDFs (Download full copy in 9 seconds upon purchase)PDF Preview: HJ/T 56-2000
HJ/T 56-2000: Determination of sulphur dioxide from exhausted gas of stationary source - Iodine titration method
---This is an excerpt. Full copy of true-PDF in English version (including equations, symbols, images, flow-chart, tables, and figures etc.), auto-downloaded/delivered in 9 seconds, can be purchased online: https://www.ChineseStandard.net/PDF.aspx/HJT56-2000
HJ
STANDARD OF STATE ENVIRONMENTAL
PROTECTION ADMINISTRATION
Determination of sulphur dioxide from exhausted gas
of stationary source - Iodine titration method
Issued on: DECEMBER 07, 2000
Implemented on: MARCH 1, 2001
Issued by. State Environmental Protection Administration of PRC
Table of Contents
Foreword ... 3
1 Scope ... 4
2 Normative references ... 4
3 Determination method-principle, determination range and determination
error ... 4
4 Influential factors ... 4
5 Apparatus ... 5
6 Reagents ... 5
7 Sampling ... 7
8 Determination ... 8
9 Calculation ... 8
10 Calculation of sulfur dioxide emission rate ... 8
Foreword
This Standard specifies the iodine titration method to determine the concentration of
sulphur dioxide from exhausted gas of stationary source as well as its total emission.
During the formulating, this Standard referred to the national standard. GB/T 16157-
1996 “The determination of particulates and sampling methods of gaseous pollutants
emitted from exhaust gas of stationary source” and parts of “Air and waste gas
monitoring analysis method” issued by State Environmental Protection Administration
in 1990. It also referred to relevant sampler’s technical indicators and domestic-foreign
enterprise standards.
This Standard was proposed by Department of Science, Technology and Standards of
State Environmental Protection Administration.
This Standard was drafted by China National Environmental Monitoring Center.
This Standard shall be interpreted by State Environmental Protection Administration.
Determination of sulphur dioxide from exhausted gas
of stationary source - Iodine titration method
1 Scope
This Standard specifies the iodine titration method to determine the concentration of
sulphur dioxide from exhausted gas of stationary source as well as the determination
of sulfur dioxide emission rate.
2 Normative references
The following standard contains the provisions which, through reference in this
Standard, constitute the provisions of this Standard. It has the same effect as this
Standard.
GB/T 16157-1996 The determination of particulates and sampling methods of
gaseous pollutants emitted from exhaust gas of stationary source
3 Determination method-principle, determination range and
determination error
Sulfur dioxide from exhausted gas is absorbed by the mixed solution of ammonium
sulfamate. Use iodine standard solution to titrate. Calculate the sulfur dioxide
concentration according to the titration. Reactions are shown as follows.
Determination range. 100 ~ 6000 mg/m3; within the determination range, the batch
error of the method shall not be greater than ± 6%.
4 Influential factors
4.1 When boiler fuel is burning under normal conditions, the content of reducing
substances such as H2S in the exhausted gas is very little; its influence to the
determination is negligible.
4.2 Ammonium sulfamate in absorption solution can eliminate the influence of carbon
7.3 Sampling frequency
Under same working conditions, it shall determine three times in a row; take the
average value as determination result.
8 Determination
After sampling, it shall titrate the sample as soon as possible. The sample shall not be
placed for more than 1h. Move all samples in two absorption bottles into the iodine
bottle. Use a small amount of absorption solution (6.1) to respectively wash the
absorption bottle twice. Move the washing solution into the iodine bottle as well. Shake
well. When adding 50 ml of 2 g/L starch solution (6.3), use 0.010 mol/L iodine standard
solution (6.8) to titrate to blue. Record the consumption V (ml).
Separately, take the absorption solution (6.1) of same volume. Conduct blank titration
in the same method. Record the consumption V0 (ml).
If the sulfur dioxide concentration of the gas is high, it shall take part of absorption
solution to titrate. At this time, the result calculated according the equation listed in
Clause 9 shall be divided by the ratio of partial absorption solution accounting for total
absorption solution.
9 Calculation
Where,
c’ - sulfur dioxide concentration of dry gas under standard conditions (mg/m3);
c(1/2 I2) - concentration of iodine stock solution (mol/L);
Vnd - sampling volume of dry gas under standard conditions (L);
32.0 - the mass (g) of sulfur dioxide (1/2 SO2) that is equal to 1 L of 1 mol/L iodine
standard solution (1/2 I2).
10 Calculation of sulfur dioxide emission rate
10.1 Determination and calculation of exhausted gas flow
According to provisions in 7.1 ~ 7.5 of GB/T 16157-1996, measure the exhaust flow
rate. According to provisions in 7.6, calculate dry exhaust gas flow Qsn (m3/h) under
standard conditions.
Where,
Qsn - dry exhaust gas flow under standard conditions.
10.2 Calculation of sulfur dioxide emission rate
10.2.1 When sulfur dioxide concentration is represented in ppm (V/V), its concentration
c can be converted to sulfur dioxide concentration of dry gas under standard conditions,
according to the following equation.
Where,
c’ - sulfur dioxide concentration of dry gas under standard conditions (mg/m3).
10.2.2 Calculation of sulfur dioxide emission rate G
......
Source: Above contents are excerpted from the full-copy PDF -- translated/reviewed by: www.ChineseStandard.net / Wayne Zheng et al.
Tips & Frequently Asked QuestionsQuestion 1: How long will the true-PDF of English version of HJ/T 56-2000 be delivered?Answer: The full copy PDF of English version of HJ/T 56-2000 can be downloaded in 9 seconds, and it will also be emailed to you in 9 seconds (double mechanisms to ensure the delivery reliably), with PDF-invoice. Question 2: Can I share the purchased PDF of HJ/T 56-2000_English with my colleagues?Answer: Yes. The purchased PDF of HJ/T 56-2000_English will be deemed to be sold to your employer/organization who actually paid for it, including your colleagues and your employer's intranet. Question 3: Does the price include tax/VAT?Answer: Yes. Our tax invoice, downloaded/delivered in 9 seconds, includes all tax/VAT and complies with 100+ countries' tax regulations (tax exempted in 100+ countries) -- See Avoidance of Double Taxation Agreements (DTAs): List of DTAs signed between Singapore and 100+ countriesQuestion 4: Do you accept my currency other than USD?Answer: Yes. www.ChineseStandard.us -- HJ/T 56-2000 -- Click this link and select your country/currency to pay, the exact amount in your currency will be printed on the invoice. Full PDF will also be downloaded/emailed in 9 seconds. How to buy and download a true PDF of English version of HJ/T 56-2000?A step-by-step guide to download PDF of HJ/T 56-2000_EnglishStep 1: Visit website https://www.ChineseStandard.net (Pay in USD), or https://www.ChineseStandard.us (Pay in any currencies such as Euro, KRW, JPY, AUD).
Step 2: Search keyword "HJ/T 56-2000".
Step 3: Click "Add to Cart". If multiple PDFs are required, repeat steps 2 and 3 to add up to 12 PDFs to cart.
Step 4: Select payment option (Via payment agents Stripe or PayPal).
Step 5: Customize Tax Invoice -- Fill up your email etc.
Step 6: Click "Checkout".
Step 7: Make payment by credit card, PayPal, Google Pay etc. After the payment is completed and in 9 seconds, you will receive 2 emails attached with the purchased PDFs and PDF-invoice, respectively.
Step 8: Optional -- Go to download PDF.
Step 9: Optional -- Click Open/Download PDF to download PDFs and invoice.
See screenshots for above steps: Steps 1~3 Steps 4~6 Step 7 Step 8 Step 9
|