GB/T 14345-2008 PDF English
US$210.00 · In stock · Download in 9 secondsGB/T 14345-2008: Testing method for twist of man-made filament Delivery: 9 seconds. True-PDF full-copy in English & invoice will be downloaded + auto-delivered via email. See step-by-step procedureStatus: Valid GB/T 14345: Evolution and historical versions
| Standard ID | Contents [version] | USD | STEP2 | [PDF] delivery | Name of Chinese Standard | Status |
| GB/T 14345-2008 | English | 210 |
Add to Cart
|
0-9 seconds. Auto-delivery
|
Testing method for twist of man-made filament
| Valid |
| GB/T 14345-2003 | English | 359 |
Add to Cart
|
3 days
|
Testing method for twist of synthetic filament yarns
| Obsolete |
| GB/T 14345-1993 | English | 239 |
Add to Cart
|
2 days
|
Testing method for twist of synthetic filament yarns
| Obsolete |
Excerpted PDFs (Download full copy in 9 seconds upon purchase)PDF Preview: GB/T 14345-2008
GB/T 14345-2008: Testing method for twist of man-made filament---This is an excerpt. Full copy of true-PDF in English version (including equations, symbols, images, flow-chart, tables, and figures etc.), auto-downloaded/delivered in 9 seconds, can be purchased online: https://www.ChineseStandard.net/PDF.aspx/GBT14345-2008
GB
NATIONAL STANDARD OF THE
PEOPLE’S REPUBLIC OF CHINA
ICS 59.060.01
W 50
Replacing GB/T 14345-2003
Testing method for twist of man-made filament
(BISFA-2004, Testing methods for polyester filament yarns,
BISFA-2004, Testing methods for polyamide filament yarns,
BISFA-1997, Testing methods for viscose, cupro, acetate, triacetate and
lyocell filament yarns, NEQ)
ISSUED ON: JUNE 18, 2008
IMPLEMENTED ON: MARCH 01, 2009
Issued by: General Administration of Quality Supervision, Inspection and
Quarantine of the PRC;
Standardization Administration of the PRC.
Table of Contents
Foreword ... 3
1 Scope ... 5
2 Normative references ... 5
3 Terms and definitions ... 5
4 Principle ... 6
5 Instruments and tools ... 6
6 General rules of testing ... 6
7 Testing procedures ... 9
8 Result calculation ... 10
9 Tolerances ... 11
10 Indication of twist and direction of twist ... 11
11 Testing report ... 12
Appendix A (Informative) Rapid conditioning method ... 13
Appendix B (Informative) Method for obtaining pretension ... 14
Appendix C (Normative) Statistics: terminology and calculations ... 15
Testing method for twist of man-made filament
1 Scope
This Standard specifies the testing method for twist of man-made fibre filaments
such as polyester, polyamide (chinlon), polypropylene, cellulose fibre.
[Translator note: There is additional 1 nick-name for polyester and
polypropylene respectively in Chinese.]
This Standard applies to the determination of the twist of man-made fibre
filaments with twist. The man-made fibre filament drawn from the fabric can
refer to it for use.
This Standard does not apply to filaments with an elongation greater than 0.5%
when the tension increases from 0.05 cN/dtex to 0.1 cN/dtex.
2 Normative references
The following documents contain provisions which, through reference in this
Standard, constitute provisions of this Standard. For the dated references, their
subsequent amendments (excluding corrections) or revisions do not apply to
this Standard. However, the parties who enter into agreement based on this
Standard are encouraged to investigate whether the latest editions of these
documents are applicable. For undated reference documents, the latest
editions apply to this Standard.
GB/T 3291.1 Textiles - Terms of textile material properties and test - Part 1:
Fibre and yarn
GB/T 3291.3 Textiles - Terms of textile material properties and test - Part 3:
General
GB/T 6502 Sampling method of man-made filament yarns
GB/T 6529 Textiles - Standard atmospheres for conditioning and testing
GB/T 8170 Rules of rounding off for numerical values and expression and
judgement of limiting values
3 Terms and definitions
The terms and definitions established in GB/T 3291.1 and GB/T 3291.3 apply
In the process of removing the sample, it shall avoid the loss of twist and
accidental stress on the sample.
Note: Do not take out rolls which have been accidentally damp, scratched or whose
packages have been opened during transportation.
6.2 Standard atmospheres for preconditioning, conditioning and testing
USE standard atmospheres for conditioning and testing of textiles specified in
GB/T 6529.
6.2.1 Preconditioning
When the moisture regain of the sample is greater than the conventional
moisture regain, preconditioning is required:
- Temperature does not exceed 50 °C;
- Relative humidity is 5%~25%;
- Time is greater than 30 min.
6.2.2 Standard atmospheres for conditioning and testing
Standard atmosphere for conditioning used by polyester and polypropylene
filaments:
- Temperature is (20±2)°C;
- Relative humidity is (65±5)%;
- Conditioning time is 4 h.
Standard atmosphere for conditioning and testing used by other man-made
fibre filaments:
- Temperature is (20±2)°C;
- Relative humidity is (65±2)%;
- Recommended conditioning time is 16 h.
See Appendix A for the conditioning time agreed by both parties.
6.3 Pretension
6.3.1 The pretension of the sample is calculated according to formula (1):
7 Testing procedures
7.1 Determination of direction of twist
TAKE a sample with a length of about 100 mm; HOLD one end to hang it;
observe the inclined direction of the vertical helix. Those that are consistent with
the middle part of the letter "S" are "S" twists. Those that are consistent with the
middle part of the letter "Z" are "Z" twists.
7.2 Multifilament testing
Before the test, pull off the filament that may be injured on the surface for
several meters. CLAMP one end of the sample into the fixed gripper; USE the
tensioning device to apply the specified pretension. After clamping the other
end of the sample into the rotating gripper, remove the twist of the sample, until
the components of the multifilament are parallel to each other. Or use an
analysis needle to pass from the sample at one end of the fixed gripper to the
sample end of the rotating gripper; determine the twist; verify the direction of
twist.
7.3 Strand testing
7.3.1 The strand testing shall be carried out according to the method for
multifilament of 7.2.
7.3.2 To determine the twist of each component of the strand, each component
can be used as a new sample to be determined according to 7.2.
For each component to be determined, the pretension shall be calculated
according to the nominal linear density of each component. Before measuring
the number of turns, reset the initial length.
7.3.2.1 Same components
If the components of the strands are the same, for the multifilament that has
been separated by the first untwisting operation, except for leaving one
multifilament, cut off other separated components near the gripper. The
remaining one is used to determine the twist.
7.3.2.2 Different components
After the strands are untwisted according to the method described in 7.2, use
adhesive tape to fix the ends of each component. Each component is marked
so that it can be distinguished during the next determination. Then cut them
from between the grippers. Since this result will not maintain the original length,
11 Testing report
The testing report includes:
a) Name and specification of sample;
b) Number identification selected as the batch sample package;
c) Testing method used and all testing parameters;
d) Individual performance test results of laboratory samples; if the standard
deviation and coefficient of variation are calculated, they shall be written
into the report;
e) Reminders on modification of testing procedures after negotiation and
other parts that are inconsistent with this Standard;
f) Observed anomalies;
g) Test personnel, test date.
......
Source: Above contents are excerpted from the full-copy PDF -- translated/reviewed by: www.ChineseStandard.net / Wayne Zheng et al.
Tips & Frequently Asked QuestionsQuestion 1: How long will the true-PDF of English version of GB/T 14345-2008 be delivered?Answer: The full copy PDF of English version of GB/T 14345-2008 can be downloaded in 9 seconds, and it will also be emailed to you in 9 seconds (double mechanisms to ensure the delivery reliably), with PDF-invoice. Question 2: Can I share the purchased PDF of GB/T 14345-2008_English with my colleagues?Answer: Yes. The purchased PDF of GB/T 14345-2008_English will be deemed to be sold to your employer/organization who actually paid for it, including your colleagues and your employer's intranet. Question 3: Does the price include tax/VAT?Answer: Yes. Our tax invoice, downloaded/delivered in 9 seconds, includes all tax/VAT and complies with 100+ countries' tax regulations (tax exempted in 100+ countries) -- See Avoidance of Double Taxation Agreements (DTAs): List of DTAs signed between Singapore and 100+ countriesQuestion 4: Do you accept my currency other than USD?Answer: Yes. www.ChineseStandard.us -- GB/T 14345-2008 -- Click this link and select your country/currency to pay, the exact amount in your currency will be printed on the invoice. Full PDF will also be downloaded/emailed in 9 seconds. Question 5: Should I purchase the latest version GB/T 14345-2008?Answer: Yes. Unless special scenarios such as technical constraints or academic study, you should always prioritize to purchase the latest version GB/T 14345-2008 even if the enforcement date is in future. Complying with the latest version means that, by default, it also complies with all the earlier versions, technically. How to buy and download a true PDF of English version of GB/T 14345-2008?A step-by-step guide to download PDF of GB/T 14345-2008_EnglishStep 1: Visit website https://www.ChineseStandard.net (Pay in USD), or https://www.ChineseStandard.us (Pay in any currencies such as Euro, KRW, JPY, AUD).
Step 2: Search keyword "GB/T 14345-2008".
Step 3: Click "Add to Cart". If multiple PDFs are required, repeat steps 2 and 3 to add up to 12 PDFs to cart.
Step 4: Select payment option (Via payment agents Stripe or PayPal).
Step 5: Customize Tax Invoice -- Fill up your email etc.
Step 6: Click "Checkout".
Step 7: Make payment by credit card, PayPal, Google Pay etc. After the payment is completed and in 9 seconds, you will receive 2 emails attached with the purchased PDFs and PDF-invoice, respectively.
Step 8: Optional -- Go to download PDF.
Step 9: Optional -- Click Open/Download PDF to download PDFs and invoice.
See screenshots for above steps: Steps 1~3 Steps 4~6 Step 7 Step 8 Step 9
|