GB/T 708-1988 PDF in English
GB/T 708-1988 (GB/T708-1988, GBT 708-1988, GBT708-1988)
| Standard ID | Contents [version] | USD | STEP2 | [PDF] delivered in | Name of Chinese Standard | Status |
| GB/T 708-1988 | English | 190 |
Add to Cart
|
0-9 seconds. Auto-delivery.
|
Dimensions shape weight and tolerances for cold-rolled plates and sheets
| Obsolete |
| GB/T 708-2019 | English | 105 |
Add to Cart
|
0-9 seconds. Auto-delivery.
|
Dimension, shape, weight and tolerance for cold-rolled steel strip and sheet
| Valid |
Newer version: GB/T 708-2019 Standards related to: GB/T 708-2019
PDF Preview
GB/T 708-1988: PDF in English (GBT 708-1988) GB 708-88
GB
NATIONAL STANDARD
OF THE PEOPLE’S REPUBLIC OF CHINA
UDC 669.14-418
Replacing GB 708-65
Dimensions, shape, weight and tolerances for cold-
rolled plates and sheets
ISSUED ON. FEBRUARY 15, 1988
IMPLEMENTED ON. JULY 1, 1989
Issued by. Ministry of Metallurgical Industry
Table of Contents
1 Classification and code ... 3
2 Definition ... 3
3 Size ... 3
4 Size tolerance ... 4
5 Appearance ... 7
6 Size measurement ... 8
7 Weight ... 8
Additional information ... 9
Dimensions, shape, weight and tolerances for cold-
rolled plates and sheets
This Standard applies to cold-rolled plates [Translator note. to align with ISO
16162-2000 and Clause 3 of GB 708-2006, hereafter “plate” is indicated as
“sheet”] of which the width exceeds or equals to 600 mm, thickness is 0.2 ~ 5
mm, and cold-rolled sheets [Translator note. to align with ISO 16162-2000 and
Clause 3 of GB 708-2006, hereafter “sheet” is indicated as “strip”] of which the
thickness exceeds 3 mm. It is not applicable to narrow strips of which the direct
rolling width is less than 600 mm.
1 Classification and code
1.1 Classify according to edge state
Trimming Q
Un-trimming BQ
1.2 Classify according to rolling precision
High precision A
Common precision B
2 Definition
2.1 Sheets are flat, rectangle, which can be directly rolled or cut from wide
strip greater than 600 mm.
2.2 Strips refer to wide strip of which the width is not less than 600 mm, which
are delivered in coil-form.
3 Size
3.1 Thickness, width of sheet and strip, length of sheet shall comply with
provisions of Table 1.
3.2 Width of sheet and strip shall be any multiple-length of 10 mm. Length of
sheet is any multiple-length of 50 mm.
Calculate steel density in accordance with theoretical weight; carbon steel’s
density is 7.85 g/cm3. The density of other steels shall be in accordance with
other relevant standards.
Example for marking.
Designation is 20, size is 1.0 mm × 1000 mm × 1500 mm, surface mass group
is II, elongation level is S, it shall be marked as.
Sheet
Additional information
This Standard was drafted by Ministry of Metallurgical Industry Institute of
Research on Information Standards, Anshan Iron and Steel Company.
Main drafters of this Standard. Wang Limin, Tang Yifan, Wang Huifan.
Level mark of this Standard. GB 708-88 I
......
Source: Above contents are excerpted from the PDF -- translated/reviewed by: www.chinesestandard.net / Wayne Zheng et al.
|